Service Manual

log-adjacency-changes
To send a Syslog message about changes in the OSPF adjacency state, set Dell Networking OS.
S4048–ON
Syntax
log-adjacency-changes
To disable the Syslog messages, use the no log-adjacency-changes command.
Defaults Disabled.
Command Modes ROUTER OSPF
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Version Description
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Added support for Multi-Process OSPF.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre- 6.1.1.1 Introduced on the E-Series.
maximum-paths
Enable the software to forward packets over multiple paths.
S4048–ON
Syntax
maximum-paths number
To disable packet forwarding over multiple paths, use the no maximum-paths command.
Parameters
number Specify the number of paths. The range for OSPFv2 is from 1 to 64. The default for
OSPFv2 is 4 paths. The range for OSPFv3 is from 1 to 64. The default for OSPFv3
is 8 paths.
Defaults 4
Command Modes ROUTER OSPF for OSPFv2
ROUTER OSPFv3 for OSPFv3
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
Networking OS Command Line Reference Guide.
Open Shortest Path First (OSPFv2 and OSPFv3) 997