Service Manual

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

991

992

993

994

995

996

997

998

999

1000

Table Of Contents

Version Description

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

9.1(0.0) Introduced support for OSPFv3 on the S4810 and Z9000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Added support for Multi-Process OSPF.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

pre- 6.1.1.1 Introduced on the E-Series.

network area

Define which interfaces run OSPF and the OSPF area for those interfaces.

S4048–ON

Syntax

network ip-address mask area area-id

To disable an OSPF area, use the no network ip-address mask area area-id command.

Parameters

ip-address

Specify a primary or secondary address in dotted decimal format. The primary

address is required before adding the secondary address.

mask

Enter a network mask in /prefix format. (/x)

area-id

Enter the OSPF area ID as either a decimal value or in a valid IP address. Decimal

value range is from 0 to 65535. IP address format is dotted decimal format

A.B.C.D.

NOTE: If the area ID is smaller than 65535, it is converted to a decimal value.

For example, if you use an area ID of 0.0.0.1, it is converted to 1.

Command Modes ROUTER OSPF

Command

History

This guide is platform-specific. For command information about other platforms, see the relevant Dell

Networking OS Command Line Reference Guide.