Administrator Guide

• Configuring a prefix list
• Use a prefix list for route redistribution
For a complete listing of all commands related to prefix lists, refer to the Dell Networking OS Command Line Interface Reference Guide.
Creating a Prefix List
To create a prefix list, use the following commands.
1 Create a prefix list and assign it a unique name.
You are in PREFIX LIST mode.
CONFIGURATION mode
ip prefix-list prefix-name
2 Create a prefix list with a sequence number and a deny or permit action.
CONFIG-NPREFIXL mode
seq sequence-number {deny | permit} ip-prefix [ge min-prefix-length] [le max-prefix-length]
The optional parameters are:
• ge min-prefix-length: the minimum prefix length to match (from 0 to 32).
• le max-prefix-length: the maximum prefix length to match (from 0 to 32).
Example of Assigning Sequence Numbers to Filters
If you want to forward all routes that do not match the prefix list criteria, configure a prefix list filter to permit all routes (permit
0.0.0.0/0 le 32). The “permit all” filter must be the last filter in your prefix list. To permit the default route only, enter permit
0.0.0.0/0
.
The following example shows how the seq command orders the filters according to the sequence number assigned. In the example, filter
20 was configured before filter 15 and 12, but the
show config command displays the filters in the correct order.
Dell(conf-nprefixl)#seq 20 permit 0.0.0.0/0 le 32
Dell(conf-nprefixl)#seq 12 deny 134.23.0.0 /16
Dell(conf-nprefixl)#seq 15 deny 120.23.14.0 /8 le 16
Dell(conf-nprefixl)#show config
!
ip prefix-list juba
seq 12 deny 134.23.0.0/16
seq 15 deny 120.0.0.0/8 le 16
seq 20 permit 0.0.0.0/0 le 32
Dell(conf-nprefixl)#
NOTE
: The last line in the prefix list Juba contains a “permit all” statement. By including this line in a prefix list, you specify that
all routes not matching any criteria in the prefix list are forwarded.
To delete a filter, use the
no seq sequence-number command in PREFIX LIST mode.If you are creating a standard prefix list with
only one or two filters, you can let Dell Networking OS assign a sequence number based on the order in which the filters are configured.
The Dell Networking OS assigns filters in multiples of five.
Creating a Prefix List Without a Sequence Number
To create a filter without a specified sequence number, use the following commands.
1 Create a prefix list and assign it a unique name.
CONFIGURATION mode
130
Access Control Lists (ACLs)