Administrator Guide

dot1p Value in
the Incoming
Frame
Egress Queue Assignment
4 2
5 3
6 3
7 3
dot1p Value in
the Incoming
Frame
Egress Queue Assignment
0 2
1 0
2 1
3 3
4 4
5 5
6 6
7 7
Configuring the Dynamic Buffer Method
Priority-based flow control using dynamic buffer spaces is supported on the switch.
To configure the dynamic buffer capability, perform the following steps:
1 Enable the DCB application. By default, DCB is enabled and link-level flow control is disabled on all interfaces.
CONFIGURATION mode
dcb enable
2 Configure the shared PFC buffer size and the total buffer size. A maximum of 4 lossless queues are supported.
CONFIGURATION mode
dcb pfc-shared-buffer-size value
dcb pfc-total-buffer-size value
The buffer size range is from 0 to 3399. Default is 3088.
3 Configure the number of PFC queues.
CONFIGURATION mode
dcb enable pfc-queues pfc-queues
The number of ports supported based on lossless queues configured depends on the buffer.
For each priority, you can specify the shared buffer threshold limit, the ingress buffer size, buffer limit for pausing the acceptance of
packets, and the buffer offset limit for resuming the acceptance of received packets.
4 Configure the profile name for the DCB buffer threshold
Data Center Bridging (DCB)
285