Administrator Guide

• Members can have different Link MTU values. Tagged members must have a link MTU 4–bytes higher than untagged members to
account for the packet tag.
• The VLAN link MTU and IP MTU must be less than or equal to the link MTU and IP MTU values configured on the VLAN members.
For example, the VLAN contains tagged members with Link MTU of 1522 and IP MTU of 1500 and untagged members with Link MTU of
1518 and IP MTU of 1500. The VLAN’s Link MTU cannot be higher than 1518 bytes and its IP MTU cannot be higher than 1500 bytes.
Port-Pipes
A port pipe is a Dell Networking-specific term for the hardware packet-processing elements that handle network traffic to and from a set
of front-end I/O ports. The physical, front-end I/O ports are referred to as a
port-set. In the command-line interface, a port pipe is
entered as port-set port-pipe-number.
Auto-Negotiation on Ethernet Interfaces
By default, auto-negotiation of speed and full duplex mode is enabled on 10/100/1000 Base-T Ethernet interfaces. Only 10GE interfaces do
not support auto-negotiation.
When using 10GE interfaces, verify that the settings on the connecting devices are set to no auto-negotiation.
The local interface and the directly connected remote interface must have the same setting, and auto-negotiation is the easiest way to
accomplish that, as long as the remote interface is capable of auto-negotiation.
NOTE: As a best practice, Dell Networking recommends keeping auto-negotiation enabled. Only disable auto-negotiation on
switch ports that attach to devices not capable of supporting negotiation or where connectivity issues arise from interoperability
issues.
Setting the Speed of Ethernet Interfaces
To discover whether the remote and local interface requires manual speed synchronization, and to manually synchronize them if
necessary, use the following command sequence.
1 Determine the local interface status. Refer to the following example.
EXEC Privilege mode
show interfaces [interface | stack—unit stack-unit-number] status
2 Determine the remote interface status.
EXEC mode or EXEC Privilege mode
[Use the command on the remote system that is equivalent to the first command.]
3 Access CONFIGURATION mode.
EXEC Privilege mode
config
4 Access the port.
CONFIGURATION mode
interface interface-type
5 Set the local port speed.
INTERFACE mode
speed {10 | 100 | 1000 | 10000 | auto}
422
Interfaces