Administrator Guide

2 Member not present
3 Standby online S4810 S4810 8-3-7-13 64
The following example shows removing a stack member (after).
Dell#show system brief
Stack MAC : 00:01:e8:8a:df:e6
Reload Type : normal-reload
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
-------------------------------------------------------
0 Management online S4810 S4810 8-3-7-13 64
1 Member not present S4810
2 Member not present
3 Standby online S4810 S4810 8-3-7-13 64
4 Member not present
5 Member not present
6 Member not present
7 Member not present
8 Member not present
9 Member not present
10 Member not present
11 Member not present
Removing Front End Port Stacking
To remove the configuration on the front end ports used for stacking, use the following commands.
1 Remove the stack group configuration that is configured.
CONFIGURATION mode
no stack-unit id stack-group id
2 Save the stacking configuration on the ports.
EXEC Privilege mode
write memory
3 Reload the switch.
EXEC Privilege mode
reload
After the units are reloaded, the system reboots. The units come up as standalone units after the reboot completes.
Troubleshoot a Stack
To troubleshoot a stack, use the following recovery tasks.
• Recover from Stack Link Flaps
• Recover from a Card Problem State on a Stack
916
Stacking