Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

1161

Parameters

interface-cost

Enter a unsigned integer value expressed as the link-state metric. The range is from 1 to

65535.

Defaults Default cost based on the bandwidth.

Command Modes INTERFACE

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.2(1.0) Introduced on the Z9500.

9.1.(0.0) Introduced on the S4810 and Z9000.

7.8.1.0 Added support for C-Series.

7.4.1.0 Introduced on the E-Series.

8.3.19.0 Introduced on the S4820T.

Usage Information

In general, the path cost is calculated as:

10^8 / bandwidth

Using this formula, the default path cost is calculated as:

• GigabitEthernet — Default cost is 1

• TenGigabitEthernet — Default cost is 1

• FortygigEthernet — Default cost is 1

• Ethernet — Default cost is 10

ipv6 ospf dead-interval

Set the time interval since the last hello-packet was received from a router. After the time interval elapses, the neighboring routers declare

the router down.

Syntax

ipv6 ospf dead-interval seconds

To return to the default time interval, use the no ipv6 ospf dead-interval command.

Parameters

seconds

Enter the time interval in seconds. The range is from 1 to 65535 seconds.

Defaults 40 seconds (Ethernet).