Administrator Guide

written destination MAC are forwarded through the outgoing port on the same incoming VLAN interface. The l2-
switch option ensures that the outgoing VLAN and MAC-SA are changed and TTL is not decremented.
Related
Commands
• show cam pbr – display the content of the PBR CAM.
• show ip redirect-list – display the redirect-list configuration.
ip redirect-list
Configure a redirect list and enter REDIRECT-LIST mode.
Syntax
ip redirect-list redirect-list-name
To remove a redirect list, use the no ip redirect-list command.
Parameters
redirect-list-name Enter the name of a redirect list.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series.
6.5.3.0 Introduced on the E-Series.
permit
Configure a permit rule. A permit rule excludes the matching packets from PBR classification and routes them using conventional routing.
Syntax
permit {ip-protocol-number | protocol-type} {source mask | any | host ip-
address} {destination mask | any | host ip-address} [bit] [operators]
To remove the rule, use one of the following:
• If you know the filter sequence number, use the no seq sequence-number syntax command.
• You can also use the no permit {ip-protocol-number | protocol-type} {source mask |
any | host ip-address} {destination mask | any | host ip-address} [bit]
[operators] command.
1186 Policy-based Routing (PBR)