Administrator Guide

interface Enter the following keywords and slot/port or number information:
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a Port Channel interface, enter the keywords port-channel then a number.
• For a VLAN, enter the keyword vlan then a number from 1 to 4094.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port
/subport[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
hash-mask-length (OPTIONAL) Enter the hash mask length. The range is from four (4) to 32. The default is
four (4).
priority (OPTIONAL) Enter the priority used in Bootstrap election process. The range is from zero
(0) to 255. The default is zero (0).
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
6.1.1.0 Added support for the VLAN interface.
ip pim dr-priority
Change the designated router (DR) priority for the interface.
Syntax
ip pim dr-priority priority-value
To remove the DR priority value assigned, use the no ip pim dr-priority command.
Parameters
priority-value Enter a number. Preference is given to larger/higher number. The range is from 0 to
4294967294. The default is 1.
Defaults 1
Command Modes INTERFACE
1198 PIM-Sparse Mode (PIM-SM)