Administrator Guide

show ip pim neighbor
View PIM neighbors.
S4048–ON
Syntax
show ip pim [vrf vrf-name] neighbor
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure this
setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default
VRF.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for VRF. Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
8.1.1.0 Introduced on the E-Series.
7.8.1.0 Introduced on the S-Series.
Usage Information The following describes the show ip pim neighbor command shown in the following example.
Field Description
Neighbor address Displays the IP address of the PIM neighbor.
Interface List the interface type, with either slot/port information or ID (VLAN or Port Channel), on
which the PIM neighbor was found.
Uptime/expires Displays the amount of time the neighbor has been up then the amount of time until the
neighbor is removed from the multicast routing table (that is, until the neighbor hold time
expires).
Ver Displays the PIM version number.
• v2 = PIM version 2
DR prio/Mode Displays the Designated Router priority and the mode.
• 1 = default Designated Router priority (use the ip pim dr-priority command)
1212 PIM-Sparse Mode (PIM-SM)