Administrator Guide

Field Description
DR Prio Displays the Designated Router priority value configured on the interface (ip pim dr-
priority command).
DR Displays the IP address of the Designated Router for that interface.
Example (#2)
DellEMC# show ip pim snooping interface
Interface Ver Nbr DR DR
Count Prio
Vlan 2 v2 3 1 165.87.32.2
DellEMC#
show ip pim snooping neighbor
Display information on PIM neighbors learned through PIM-SM snooping.
Syntax
show ip pim snooping neighbor [vlan vlan-id]
Parameters
vlan vlan-id (OPTIONAL) Enter a VLAN ID to display information about PIM neighbors that PIM-SM
snooping discovered on a specified VLAN. The valid VLAN IDs range is from 1 to 4094.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.4.1.1 Introduced on the E-Series.
Usage Information The following describes the show ip pim snooping neighbor commands shown in the following example.
Field Description
Neighbor address Displays the IP address of the neighbor learned through PIM-SM snooping.
Interface Displays the VLAN ID number and slot/port on which the PIM-SM-enabled neighbor was
discovered.
Uptime/expires Displays the amount of time the neighbor has been up then the amount of time until the
neighbor is removed from the multicast routing table (that is, until the neighbor hold time
expires).
Ver Displays the PIM version number:
• v2 = PIM version 2
DR prio/Mode Displays the Designated Router priority and the mode:
• 1 = default Designated Router priority (use the ip pim dr-priority command)
• DR = Designated Router
• S = Sparse mode
PIM-Sparse Mode (PIM-SM) 1215