Administrator Guide

NOTE: Applies to specific VRF if input is provided, else applies to Default
VRF.
bsr (OPTIONAL) Enter the keyword bsr to invoke debugging of IPv6 PIM Candidate
RP/BSR activities.
events (OPTIONAL) Enter the keyword events to invoke debugging of IPv6 PIM events.
group [ group ] (OPTIONAL) Enter the keyword group followed by the group address to invoke
debugging on that specific group.
packet (OPTIONAL) Enter the keyword packet to invoke debugging of IPv6 PIM packets.
register [ group ] (OPTIONAL) Enter the keyword register and optionally the group address to invoke
debugging of IPv6 PIM register messages for a particular group.
state (OPTIONAL) Enter the keyword state to view IPv6 PIM state changes.
timer [assert |
hello | joinprune |
register]
(OPTIONAL) Enter the keyword timer to view IPv6 PIM timers. Enter one of the
optional parameters:
• assert: to view the assertion timer
• hello: to view the IPv6 PIM neighbor keepalive timer
•
joinprune: to view the expiry timer (join/prune timer)
• register: to view the register suppression timer
Defaults Disabled.
Command Modes EXEC Privilege
Command History
Version Description
9.11.3.0 Introduced on the Z9100-ON, S4048-ON, S6000-ON, S6100-ON, S4048T-ON, S3100,
S6010-ON, S3048-ON, and C9010.
ipv6 pim bsr-border
Define the border of IPv6 PIM domain by filtering inbound and outbound PIM-BSR messages per interface.
Syntax
ipv6 pim bsr-border
To return to the default value, use the no ipv6 pim bsr-border command.
Defaults Disabled.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
9.14(1.0) Introduced on the C9010, S3048–ON, S3100 Series, S4048–ON, S4048T–ON, S6000–
ON, S6010–ON, S6100–ON, Z9100–ON.
Usage Information This command is applied to the subsequent PIM-BSR. Existing BSR advertisements are cleaned up by time-out.
ipv6 pim bsr-candidate
To join the Bootstrap election process, configure the PIM router as a bsr-candidate.
Syntax
ipv6 pim [vrf vrf-name] bsr-candidate interface [hash-mask-length] [priority]
To return to the default value, use the no ipv6 pim bsr-candidate [vrf vrf-name] command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf then the name of the VRF to configure the PIM
router on a VRF.
PIM-Sparse Mode (PIM-SM) 1223