Administrator Guide
ipv6 pim query-interval
Change the frequency of IPv6 PIM router-query messages.
Syntax
ipv6 pim query-interval seconds
To return to the default value, use the no ipv6 pim query-interval seconds command.
Parameters
seconds
Enter a number as the number of seconds between router query messages. The range is
from 0 to 65535. The default is 30 seconds.
Defaults 30 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version Description
9.11.3.0 Introduced on the Z9100-ON, S4048-ON, S6000-ON, S6100-ON, S4048T-ON, S3100,
S6010-ON, S3048-ON, and C9010.
ipv6 pim rp-address
Configure a static PIM rendezvous point (RP) address for a group. First-hop routers use this address to send register packets on behalf of
the source multicast host.
Syntax
ipv6 pim [vrf vrf-name] rp-address address {group-address group-address mask}
[override]
To remove an RP address, use the no ipv6 pim re-address address group-address mask
[override] command.
Parameters
vrf
vrf-name
(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to view IP PIM
debugging messages corresponding to that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default
VRF.
address
Enter the IPv6 RP address in the x:x:x:x::x format.
NOTE: The :: notation specifies successive hexadecimal fields of zero.
group-address
group-address
mask
Enter the keywords group-address then the group address in the x:x:x:x::x format and
then the mask in /nn format to assign that group address to the RP.
NOTE: The :: notation specifies successive hexadecimal fields of zero.
override (OPTIONAL) Enter the keyword override to override the BSR updates with static RP.
The override takes effect immediately during enable/disable.
NOTE: This option is applicable to multicast group range.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
PIM-Sparse Mode (PIM-SM) 1225