Administrator Guide
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced the seq option for the class-map on all the Dell EMC Networking OS
platforms.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Added the ipv6 and ip-any options on the Z9000, S6000, S4820T, S4810, MXL.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Added the keyword multicast ; added the DSCP Marking option support on the S-
Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series; added support for the DSCP Marking option.
6.2.1.1 Introduced on the E-Series.
Usage Information
To access this command, enter the class-map command. After the class map is identified, you can configure
the match criteria.
The match ip dscp and match ip precedence commands are mutually exclusive.
Up to 64 IP DSCP values can be matched in one match statement. For example, to indicate IP DCSP values 0 1 2
3 4 5 6 7, enter either the match ip dscp 0,1,2,3,4,5,6,7 or match ip dscp 0-7 command.
NOTE: Only one of the IP DSCP values must be a successful match criterion, not all of the
specified IP DSCP values must match.
Related
Commands
• class-map — identifies the class map.
match ip precedence
Use IP precedence values as a match criteria.
Syntax
[seq sequence number] match {ip | ipv6 | ip-any} precedence ip-precedence-list
[set-ip-dscp value]
To remove IP precedence as a match criteria, use the no match {ip | ipv6 | ip-any} precedence
ip-precedence-list [[multicast] set-ip-dscp value] command.
1276 Quality of Service (QoS)