Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

1281

Usage Information

This command does not uniquely identify a queue, but rather identifies only a set of queues. The WRED Curve is

applied to all eight ingress Multicast queues.

NOTE: The multicast-bandwidth option is not supported on queue ingress. If you attempt to

use the multicast-bandwidth option, the following reject error message is generated: %

Error:Bandwidth-percent is not allowed for ingress multicast.

rate-police

Specify the policing functionality on incoming traffic.

Syntax

rate-police [kbps] committed-rate [burst-KB] [peak [kbps] peak-rate [burst-KB]]

Parameters

kbps Enter the keyword kbps to specify the rate limit in Kilobits per second (Kbps). Make the

following value a multiple of 64. The range is from 0 to 40000000. The default granularity

is Megabits per second (Mbps).

committed-rate

Enter the bandwidth in Mbps. The range is from 0 to 40000.

burst-KB

(OPTIONAL) Enter the burst size in KB. The range is from 16 to 200000. The default is

100.

peak

peak-rate

(OPTIONAL) Enter the keyword peak then a number to specify the peak rate in Mbps.

The range is from 0 to 40000. The default is the same as designated for committed-

rate.

Defaults Burst size is 100KB. peak-rate is by default the same as committed-rate. Granularity for committed-

rate and peak-rate is Mbps unless you use the kbps option.

Command Modes QOS-POLICY-IN

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100-ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.2(1.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.

7.6.1.0 Introduced on the S-Series.

7.5.1.0 Introduced on the C-Series.

6.1.1.1 Introduced on the E-Series.

1288 Quality of Service (QoS)