Administrator Guide

with per queue per
port tx and drop
rates
Example of show
qos statistics
wred-profile
DellEMC(conf)#do show qos statistics wred-profile
Global Wred State : Enabled
Interface Te 1/11
Drop-statistic Dropped Pkts
Green 0
Yellow 6730113
Out of Profile 0
Usage Information
In a dual homing setup, you can use this command only from the primary VLT peer.
The following list describes output of the show qos statistics command in the example:
• Queue # — Queue Number.
• Queued Bytes — Snapshot of the byte count in that queue.
• Queued Pkts — Cumulative packet count in that queue.
• Matched Pkts — The number of packets that matched the class-map criteria.
NOTE: When you configure trust , matched packet counters are not incremented in this field.
• Matched Bytes — The number of bytes that matched the class-map criteria.
NOTE: When you configure trust , matched byte counters are not incremented in this field.
• Dropped Pkts — The total of the number of packets dropped for green, yellow and out-of-profile.
show qos wred-profile
View the WRED profile details.
Syntax
show qos wred-profile wred-profile-name
Parameters
wred-profile-name Enter the WRED profile name to view the profile details.
Defaults none
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Modified to display the global WRED state.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
1302 Quality of Service (QoS)