Administrator Guide
For the encryption-type, enter either zero (0) or 7 as the encryption type for the key
entered. The options are:
• 0 is the default and means the password is not encrypted and stored as clear text.
• 7 means that the password is encrypted and hidden.
Configure this parameter last because leading spaces are ignored.
Defaults Not configured.
Command Modes
• RADIUS SERVER GROUP
• CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14(1.5) Added support for RADIUS accounting.
9.11(0.0) Included a prompt to force the users to re-authenticate when there is a change in the
RADIUS server list.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.4.1.0 Added support for IPv6.
8.3.7.0 Introduced on the S4810.
7.7.1.0 Authentication key length increased to 42 characters.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.0 Introduced on the E-Series.
Usage Information
To configure any number of RADIUS server hosts for each server host that is configured, use this command. Dell
EMC Networking OS searches for the RADIUS hosts in the order they are configured in the software.
The global default values for the timeout, retransmit, and key optional parameters are applied, unless those
values are specified in the radius-server host or other commands. To return to the global default values, if
you configure the timeout, retransmit, or key values, include those keywords when using the no
radius-server host command syntax.
You can use duplicate host names or IP addresses among RADIUS groups. However, you cannot use duplicate
host names or IP addresses within the same RADIUS group. If a VRF is not configured on the RADIUS group, then
servers configured in the group are considered to be on the default VRF. RADIUS servers that are configured in
the CONFIGURATION mode are also considered to be on the default VRF.
1408 Security