Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

1561

Commands

• reset stack-unit – resets the designated stack member.

• show hardware stack-unit – displays the data plane or management plane input and output statistics of the

designated component of the designated stack member.

• show system – displays the current status of all stack members or a specific member.

stack-unit priority

Configure the ability of a switch to become the management unit of a stack.

Syntax

stack-unit stack-number priority priority-value

Parameters

stack-number

Enter the stack member unit identifier.

priority-value

This preference parameter allows you to specify the management priority of one backup

switch over another, with 1 as the lowest priority and 14 being the highest. The switch

with the highest priority value is chosen to become the management unit if the active

management unit fails or on the next reload.

Defaults 1

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.0) Introduced on the S6100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.7.0 Introduced on the S4810.

8.3.11.1 Introduced on the Z9000.

Commands

• reload – reboots Dell EMC Networking OS.

stack-unit provision

Preconfigure a logical stacking ID of a switch that joins the stack. This is an optional command that is executed on the management unit.

Syntax

stack-unit [stack-number] provision {model-identifier}

Parameters

stack-number

Enter a stack member identifier of the switch that you want to add to the stack.

model-identifier

Enter the model identifier of the switch to be added as a stack member. This identifier is

also referred to as the provision type.

Defaults When this value is not set, a switch joining the stack is given the next available sequential stack member identifier.