Administrator Guide

Version Description
7.6.1.0 Introduced on the C-series and S-Series.
Usage Information Broadcast traffic (all 0xFs) should be counted against the broadcast storm control meter, not against the
multicast storm control meter. It is possible, however, that some multicast control traffic may get dropped when
storm control thresholds are exceeded.
storm-control multicast (Interface)
Configure the percentage of multicast traffic allowed on an C-Series or S-Series interface (ingress only) network only.
Syntax
storm-control multicast packets_per_second in
To disable multicast storm control on the interface, use the no storm-control multicast
packets_per_second in command.
Parameters
packets_per_seco
nd in
Enter the packets per second of broadcast traffic allowed into the network. The range is
from 0 to 33554368.
Defaults none
Command Modes INTERFACE (conf-if-interface-slot/port)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the C-series and S-Series.
storm-control PFC/LLFC
Shut down the port if it receives the PFC/LLFC frames more than the configured rate.
Syntax
storm-control pfc-llfc [pps]in shutdown
Parameters
pfc-llfc in Enter the keyword pfc-llfc to get the flow control traffic. The range is from 0 to
33554368 packets per second.
shutdown Enter the keyword shutdown to shut down the port when the rate exceeds.
Defaults none
Storm Control 1571