Administrator Guide
Command Modes INTERFACE (conf-if-interface-slot/port)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.9(0.0) Introduced on the C9010, S4810, S4820T, S5000, S6000, Z9500, S3048-ON, S4048-ON,
and S6000–ON.
Usage Information
NOTE: PFC/LLFC storm control enabled interfaces disable the interfaces if it receives continuous
PFC/LLFC packets. It can be a result of a faulty NIC/Switch that sends spurious PFC/LLFC
packets.
storm-control unknown-unicast (Configuration)
Configure the percentage of unknown-unicast traffic allowed in or out of the network.
Syntax
storm-control unknown-unicast [packets_per_second in]
To disable storm control for unknown-unicast traffic, use the no storm-control unknown-unicast
[packets_per_second in] command.
Parameters
packets_per_seco
nd
in
Enter the packets per second of broadcast traffic allowed into the network. The range is
from 0 to 33554368.
Defaults none
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 E-Series Only: Added the percentage decimal value option.
6.5.1.0 Introduced on the E-Series.
Usage Information Unknown Unicast Storm-Control is valid for Layer 2 and Layer 2/Layer 3 interfaces.
1572 Storm Control