Administrator Guide

• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For the Management interface, enter the keyword ManagementEthernet then
slot/port information.
• For a port-channel interface, enter the keywords port-channel then the port-
channel ID.
• For VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14.1.0 The support for configuring management interface is introduced in S4810 and S4820T.
9.13.0.0 Added support for configuring Management interface.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.1.1.0 Introduced on the E-Series.
ntp step-threshold
Configure the step-threshold time interval.
Syntax
ntp step-threshold value
To return to the default NTP step-threshold value, use the no ntp step-threshold command.
Parameters
value Enter the threshold value in milliseconds. The range is from 128 to 5000 milliseconds (5
seconds).
Defaults 128 milliseconds
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command-Line Reference Guide.
System Time and Date 1617