Administrator Guide

Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.4(0.0) Added the decapsulate-any command.
9.3(0.1) Introduced on the S6000 and Z9000.
Usage Information
To enable a tunnel interface, use this command. You must define a tunnel mode for the tunnel to function. If you
previously defined the tunnel destination or source address, the tunnel mode must be compatible.
Including the decapsulate-any option causes the command to fail if any of the following tunnel transmit options
are configured: tunnel destination, tunnel dscp, tunnel flow-label, tunnel hop-limit, or tunnel keepalive. Conversely,
if you configure any tunnel allow-remote entries, the
tunnel—mode command fails unless the decapsulate-any
option is included.
Configuration of IPv6 commands over decapsulate-any tunnel causes an error.
tunnel source
Set a source address for the tunnel.
Syntax
tunnel source {ip-address | ipv6–address | interface-type-number | anylocal}
To delete the current tunnel source address, use the no tunnel source command.
Parameters
ip-address Enter the source IPv4 address in A.B.C.D format.
ipv6–address Enter the source IPv6 address in X:X:X:X::X format.
interface-type-
number
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port/subport[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a port-channel interface, enter the keywords port-channel then the port-
channel ID.
anylocal
Enter the anylocal command to allow the multipoint receive-only tunnel to decapsulate
tunnel packets destined to any local ip address.
Defaults none
Command Modes INTERFACE TUNNEL (conf-if-tu)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
Tunneling 1631