Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

1631

To disable upstream-link tracking without deleting the uplink-state group, use the no enable command.

Defaults Upstream-link tracking is automatically enabled in an uplink-state group.

Command Modes UPLINK-STATE-GROUP

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10.0.2 Introduced on the Z9100–ON.

9.8(2.0) Introduced on the S3100 series.

9.10(0.0) Introduced on the S3148.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.2(1.0) Introduced on the Z9500.

9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux

(PMUX) mode only.

8.3.19.0 Introduced on the S4820T

8.3.12.0 Introduced on the S4810.

8.4.2.3 Introduced on the S-Series S50.

Commands

• uplink-state-group — create an uplink-state group and enables the tracking of upstream links.

show running-config uplink-state-group

Display the current configuration of one or more uplink-state groups.

Syntax

show running-config uplink-state-group [group-id]

Parameters

group-id

Displays the current configuration of all uplink-state groups or a specified group. The valid

group-id values are from 1 to 16.

Defaults none

Command Modes

• EXEC

• EXEC Privilege