Administrator Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S-Series and Z9500.
Related
Commands
• permit bandwidth – specify link band width extended-community attribute as the matching criteria to
permitting incoming or outgoing traffic.
debug ip bgp
Display all information on BGP, including BGP events, keepalives, notifications, and updates.
Syntax
debug ip bgp [ vrf vrf-name | A.B.C.D | X:X:X:X::X | peer-group peer-group-
name] [in | out]
To disable all BGP debugging, use the no debug ip bgp command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to debug BGP information
corresponding to that VRF.
NOTE: Use this attribute to debug BGP protocol operations corresponding
to either a default or non-default VRF.
A.B.C.D Enter the IPv4 address of the neighbor in dotted decimal format.
X:X:X:X::X (OPTIONAL) Enter an IPv6 address.
peer-group peer-
group-name
Enter the keywords peer-group then the name of the peer group to debug.
in (OPTIONAL) Enter the keyword in to view only information on inbound BGP routes.
out (OPTIONAL) Enter the keyword out to view only information on outbound BGP routes.
A.B.C.D Enter the IP address of peer in the A.B.C.D format.
X:X:X:X::X Enter the IPv6 IP address of peer in the X:X:X:X::X format.
dampening Enter the keyword dampening to view BGP dampening.
events Enter the keyword events to view BGP protocol events.
ipv4 Enter the ipv4 IP address to view the IPV4 route information.
ipv6 Enter the ipv6 IP address to view the IPV6 route information.
keepalives Enter the keyword keepalives to view BGP keepalives.
notifications Enter the keyword notifications to view BGP notifications.
soft-
reconfiguration
Enter the keywords soft-reconfiguration to view only information on inbound
BGP soft reconfiguration.
updates Enter the keyword updates to view BGP updates.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
366 Border Gateway Protocol