Administrator Guide

peer-group-name Enter the name of the peer group.
All routers in the peer group receive routes from a route reflector.
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
A route reflector reflects routes to the neighbors assigned to the cluster. Neighbors in the cluster do not need not
to be fully meshed. By default, when you use no route reflector, the internal BGP (IBGP) speakers in the
network must be fully meshed.
The first time you enter this command, the router configures as a route reflector and the specified BGP neighbors
configure as clients in the route-reflector cluster.
When you remove all clients of a route reflector using the no neighbor route-reflector-client
command, the router no longer functions as a route reflector.
If the clients of a route reflector are fully meshed, you can configure the route reflector to not reflect routes to
specified clients by using the
no bgp client-to-client reflection command.
This command automatically restarts the neighbor session for the configuration to take effect.
Related
Commands
• bgp client-to-client reflection — enable route reflection between the route reflector and the clients.
neighbor send-community
Send a COMMUNITY attribute to a BGP neighbor or peer group. A COMMUNITY attribute indicates that all routes with that attribute
belong to the same community grouping.
Syntax
neighbor {ip-address | peer-group-name} send-community [extended | standard]
To disable sending a COMMUNITY attribute, use the no neighbor {ip-address | peer-group-name}
send-community command.
394 Border Gateway Protocol