Administrator Guide

Parameters
ip-address Enter the IP address of the peer router in dotted decimal format.
peer-group-name Enter the name of the peer group to send a COMMUNITY attribute to all routers within
the peer group.
extended (OPTIONAL) Enter the keyword extended to send extended community attribute.
standard (OPTIONAL) Enter the keyword standard to send standard community attribute.
Defaults Not configured and COMMUNITY attributes are not sent to neighbors.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
Version 9.0.2.0 Introduced on the S6000.
8.3.11.1 Introduced on the Z9000.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information To configure a COMMUNITY attribute, use the set community command in ROUTE-MAP mode.
In order that settings corresponding to the neighbor send-community command take effect, you must
execute the
clear ip bgp command immediately after you execute the neighbor send-community
command.
If you do not set any of the optional parameters (standard or extended), then both standard as well as extended
attributes are sent. If you set either the standard or extended parameter, only the attribute that is specified is
sent.
neighbor sender-side-loopdetect
Enables sender-side loop detection for BGP.
Syntax
neighbor {ip-address | peer-group-name} sender-side-loopdetect
To disable sender-side loop detection, use the no neighbor {ip-address | peer-group-name}
sender-side-loopdetect command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group to enable or disable all routers with in the peer group.
All routers in the peer group receive routes from a route reflector.
Defaults Enabled.
Command Modes ROUTER BGP
Border Gateway Protocol 395