Administrator Guide
ipv4
multicast
(OPTIONAL) Enter the keyword ipv4 followed by the keyword multicast to view
information related only to ipv4 multicast routes.
ipv4
unicast
(OPTIONAL) Enter the keyword ipv4 followed by the keyword unicast to view
information related only to ipv4 unicast routes.
ipv6 unicast (OPTIONAL) Enter the keyword ipv6 followed by the keyword unicast to view
information related only to ipv6 unicast routes.
ip-address
(OPTIONAL) Enter the IP address of the neighbor to view only BGP information
exchanged with that neighbor.
advertised-routes (OPTIONAL) Enter the keywords advertised-routes to view only the routes the
neighbor sent.
dampened-routes (OPTIONAL) Enter the keywords dampened-routes to view information on dampened
routes from the BGP neighbor.
detail (OPTIONAL) Enter the keyword detail to view neighbor-specific internal information
for the IPv4 Unicast address family.
flap-statistics (OPTIONAL) Enter the keywords flap-statistics to view flap statistics on the
neighbor’s routes.
routes (OPTIONAL) Enter the keyword routes to view only the neighbor’s feasible routes.
all {received-
routes [
network
[
network-mask
]}
(OPTIONAL) Enter the keywords all {received-routes} then either the network
address alone (in dotted decimal format) or the network address along with the network
mask (in slash prefix format) to view all the information received from neighbors.
NOTE: Configure the neighbor soft-reconfiguration inbound
command prior to viewing all the information received from the neighbors.
denied-routes
[
network
[
network-mask
]
(OPTIONAL) Enter the keywords denied-routes then either the network address (in
dotted decimal format) or the network mask (in slash prefix format) to view all
information on routes denied via neighbor inbound filters.
Command Modes
• EXEC
• EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.14(0.0) Introduced the [all] option for IPv4 and IPv6 neighbors.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the ipv4 multicast and ipv6 unicast parameters.
9.4.(0.0) Added support for VRF.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Added the add-path option to the S4810. Output on the S4810 shows the ADDPATH
parameters.
Border Gateway Protocol 429