Administrator Guide

Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.8.0 Introduced on the S4810.
Usage Information
This command applies the service-policy based on the type of protocol defined in the ACL rules.
Create ACL and QoS policies prior to enabling this command.
For CoPP, use the keyword cpu-qos when creating qos-policy-input.
Related
Commands
• ip access-list extended — creates an extended IP ACL.
• mac access-list extended — creates an extended MAC ACL.
• qos-policy-input — creates a QoS input policy map.
• class-map — creates a QoS class map.
• policy-map-input — creates an input policy map.
ip unknown-unicast
Enable IPv4 catch-all route.
Syntax
ip unknown-unicast [vrf vrf-name]
To remove the IPv4 catch-all route (0.0.0.0/0) from the LPM route forwarding table in hardware which gets
added as a default configuration after the initialization of FIB Agent module, use the no ip unknown-unicast
command.
Defaults None
Parameters
vrf vrf-name (Optional) Enter the keyword vrf followed by the name of the VRF to enable catch-all
routes corresponding to that VRF.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
468 Control Plane Policing (CoPP)