Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

491

492

493

494

495

496

497

498

499

500

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S6100-ON.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0) Introduced on the S3048-ON and S4048-ON.

9.7(0.0) Introduced on the S6000-ON and Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.

Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the DCBX

configuration on a port, use the show interface dcbx detail command.

debug dcbx

Enable DCBX debugging.

Syntax

debug dcbx {all | auto-detect-timer | config-exchng | fail | mgmt | resource |

sem | tlv}

To disable DCBX debugging, use the no debug dcbx command.

Parameters

{all | auto-detect-

timer | config-

exchng | fail |

mgmt | resource |

sem | tlv}

Enter the type of debugging, where:

• all: enables all DCBX debugging operations.

• auto-detect-timer: enables traces for DCBX auto-detect timers.

• config-exchng: enables traces for DCBX configuration exchanges.

• fail: enables traces for DCBX failures.

• mgmt: enables traces for DCBX management frames.

• resource: enables traces for DCBX system resource frames.

• sem: enables traces for the DCBX state machine.

• tlv: enables traces for DCBX TLVs.

Defaults None

Command Modes EXEC Privilege