Administrator Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series.
7.4.1.0 Introduced
Usage Information This command places you into the resilient ring protocol. After executing this command, the command line prompt
changes to conf-frrp.
show frrp
Display the resilient ring protocol configuration.
Syntax
show frrp [ring-id [summary]] | [summary]
Parameters
ring-id Enter the ring identification number. The range is from 1 to 255
summary (OPTIONAL) Enter the keyword summary to view just a summarized version of the Ring
configuration.
Defaults None
Command Modes EXEC
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
Usage Information Executing this command without the optional ring-id command clears the statistics counters on all the
available rings. Dell EMC Networking OS requires a command line confirmation before the command executes.
This command clears the following counters:
• hello Rx and Tx counters
• Topology change Rx and Tx counters
• The number of state change counters
616 Force10 Resilient Ring Protocol (FRRP)