Administrator Guide

Parameters
seconds Enter the number of seconds for the maximum response time. The range is from 1 to 25.
The default is 10 seconds.
Defaults 10 seconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.6.1.0 Introduced on the S-Series in Interface VLAN mode only to enable the system to act as
an IGMP Proxy Querier.
7.5.1.0 Introduced on the C-Series in Interface VLAN mode only to enable the system to act as
an IGMP Proxy Querier.
E-Series legacy
command.
ip igmp ssm-map
To translate (*,G) memberships to (S,G) memberships, use a statically configured list.
Syntax
ip igmp [vrf vrf-name] ssm-map std-access-list source-address
Undo this configuration, that is, remove SSM map (S,G) states and replace them with (*,G) state, use the ip
igmp [vrf vrf-name] ssm-map std-access-list source-address command.
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure this
setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default
VRF.
std-access-list Specify the standard IP access list that contains the mapping rules for multicast groups.
644 Internet Group Management Protocol (IGMP)