Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

641

642

643

644

645

646

647

648

649

650

source-address

Specify the multicast source address to which the groups are mapped.

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Added support for VRF and Introduced on the S6000-ON.

9.5(0.0) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

7.8.1.0 Introduced on the C-Series and S-Series.

7.7.1.0 Introduced on the E-Series.

Usage Information Mapping applies to both v1 and v2 IGMP joins; any updates to the ACL are reflected in the IGMP groups. You may

not use extended access lists with this command. When you configure a static SSM map and the router cannot

find any matching access lists, the router continues to accept (*,G) groups.

Commands

• ip access-list standard — create a standard access list to filter based on IP address.

ip igmp version

Manually set the version of the router to IGMPv2 or IGMPv3.

Syntax

ip igmp version {2 | 3}

Parameters

2 Enter the number 2 to set the IGMP version number to IGMPv2.

3 Enter the number 3 to set the IGMP version number to IGMPv3.

Defaults 2 (IGMPv2)

Command Modes INTERFACE