Administrator Guide

interface managementEthernet
Configure the Management port on the system (either the Primary or Standby RPM).
Syntax
interface managementEthernet slot/port
Parameters
slot/port
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810.
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced
Usage Information
You cannot delete a Management port.
The Management port is enabled by default (no shutdown). To assign an IP address to the Management port,
use the ip address command.
Example
DellEMC(conf)# interface managementethernet 1/1
DellEMC(conf-if-ma-1/1)#
Related
Commands
• management route — configure a static route that points to the Management interface or a forwarding
router.
• speed (Management interface) — Set the speed for the Management interface.
interface null
Configure a Null interface on the switch.
Syntax
interface null number
Parameters
number Enter zero (0) as the Null interface number.
Defaults Not configured; number = 0
Interfaces 677