Administrator Guide

Version Description
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
9.1.(0.0) Introduced on the S4810; added support for OpenFlow.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Usage Information
For more information about VLANs and the commands to configure them, see Virtual LAN (VLAN) Commands.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC ACLs and IP ACLs are supported. For more
information, see Access Control Lists (ACL).
The following features are not supported on VLANs associated with an OpenFlow instance:
IPv4
IPv6
MTU
If OpenFlow VLANs are configured on the switch, spanning-tree protocols cannot be enabled simultaneously.
Example (Single
Range)
DellEMC(conf)# int vlan 3
DellEMC(conf-if-vl-3)#
Related
Commands
interface — configure a physical interface.
interface loopback — configure a loopback interface.
interface null — configure a null interface.
interface port-channel — configure a port channel group.
show vlan — display the current VLAN configuration on the switch.
shutdown — disable/enable the VLAN.
tagged — add a Layer 2 interface to a VLAN as a tagged interface.
untagged — add a Layer 2 interface to a VLAN as an untagged interface.
intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled. To set the interface type as CR4 with autonegotiation disabled, use the no
intf-type cr4 autoneg command.
Syntax
intf-type cr4 autoneg
Defaults
Not configured
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0) Introduced on the S3048-ON and S4048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
684 Interfaces