Administrator Guide

rate-interval (Configuration Mode)
Configure the traffic sampling interval for all physical and logical port-channel interfaces globally. The support to configure rate-interval
globally enables you to modify the default interval rate for all physical and logical interfaces at one time.
Syntax
rate-interval seconds
Use the no rate-interval command to remove the sampling interval configuration.
Parameters
seconds Enter the number of seconds for which to collect traffic data. The range is from 5 to 299
seconds.
NOTE: Because polling occurs every 15 seconds, the number of seconds
designated here round to the multiple of 15 seconds lower than the entered
value. For example, if 44 seconds is designated, it rounds to 30; 45 to 59
seconds rounds to 45. If you configure this value to be less than 5, then the
entire buffer is cleared; the show int stats command shows the rate
information to be 0 as the polling interval is less than 5.
Defaults 299 seconds
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.11.0.0 Introduced on all Dell EMC Networking OS platforms.
Usage Information
The output of the show interfaces command displays the configured rate interval, along with the collected
traffic data.
When rate-interval is not configured in the global configuration mode or interface mode, the default value of 299
seconds is applied.
When rate-interval is configured only in the global configuration mode and not in the interface mode, the global
rate-interval value is applied at the interface level also.
When rate-interval is configured at the interface level and not in the global configuration mode, the interface level
rate-interval value is applied for an interface.
When rate interval is configured in both global configuration mode as well as interface mode, then the rate-
interval value configured at interface level is applied as it takes precedence over the global value.
show config
Display the interface configuration.
Syntax
show config
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
Interfaces 695