Administrator Guide

interface interface (OPTIONAL) Enter any of the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the slot/port/subport[/subport] information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port information.
port-channel (OPTIONAL) Enter the keywords port-channel if the backup port is a static or
dynamic port channel.
mode (OPTIONAL) Enter the keyword mode to set the interface mode.
private-vlan (OPTIONAL) Enter the keywords private-vlan to set the interface mode to private
VLAN mode.
host (OPTIONAL) Enter the keyword host to set the private VLAN interface to host mode.
promiscuous (OPTIONAL) Enter the keyword promiscuous to set the private VLAN interface to
promiscuous mode.
trunk (OPTIONAL) Enter the keyword trunk to set the private VLAN interface to trunk mode.
Defaults Disabled — interface is in Layer 3 mode.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.4.1.0 Added support for port-channel interfaces (the port-channel number option).
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.7.1.0 Added the backup interface option.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage Information
If an IP address or VRRP group is assigned to the interface, you cannot use the switchport command on the
interface. To use the switchport command on an interface, only the no ip address and no shutdown
statements must be listed in the show config output.
Interfaces 723