Administrator Guide

Version Description
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced for the E-Series.
Usage Information To avoid denial of service (DOS) attacks, keep the number of fragments allowed for re-assembly low.
ip max-routes
Enables you to configure the maximum number of protocol routes per VRF that are allowed for IPv4.
Syntax
ip max-routes [vrf vrf-name] max-number
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF for which you want to configure
maximum number of protocol routes that IPv4 allows.
max-number Enter the maximum number of protocol routes that a VRF RTM can hold. The range is
from 0 to 7500.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.4.(0.0) Introduced on the S4810 and S4820T.
Usage Information Use this command to specify the maximum number of protocol routes that the Route Table Manager can hold for
a specific VRF. This command does not apply to the management VRFs.
Related
Commands
• show ip route — view the switch routing table.
• show ipv6 route — display the IPv6 routes.
ip name-server
Enter up to six IPv4 addresses of name servers. The order you enter the addresses determines the order of their use.
Syntax
ip name-server ipv4-address [ipv4-address2...ipv4-address6]
To remove a name server, use the no ip name-server ip-address command.
Parameters
ipv4-address Enter the IPv4 address, in dotted decimal format, of the name server to be used.
ipv4-address2...
ipv4-address6
(OPTIONAL) Enter up five more IPv4 addresses, in dotted decimal format, of name
servers to be used. Separate the addresses with a space.
Defaults No name servers are configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
778 IPv4 Routing