Administrator Guide
Version Description
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Regular evaluation optimization enabled/disabled added to display output.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Example
DellEMC# show ip protocols
Routing Protocol is "bgp 1"
Cluster Id is set to 20.20.20.3
Router Id is set to 20.20.20.3
Fast-external-fallover enabled
Regular expression evaluation optimization enabled
Capable of ROUTE_REFRESH
For Address Family IPv4 Unicast
BGP table version is 0, main routing table version 0
Distance: external 20 internal 200 local 200
Neighbor(s):
Address : 20.20.20.2
Filter-list in : foo
Route-map in : foo
Weight : 0
Address : 5::6
Weight : 0
DellEMC#
show ip route
View information, including how they were learned, about the IP routes on the switch.
Syntax
show ip route [vrf vrf-name] hostname | ip-address [mask] [longer-prefixes] |
list prefix-list | protocol [process-id | routing-tag] | all | connected |
static | summary]
Parameters
vrf
vrf-name
(OPTIONAL) Enter the keyword vrf and then the VRF name to list the routes in the
route table of a specific VRF.
ip-address
(OPTIONAL) Specify a name of a device or the IP address of the device to view more
detailed information about the route.
mask
(OPTIONAL) Specify the network mask of the route. Use this parameter with the IP
address parameter.
longer-prefixes (OPTIONAL) Enter the keywords longer-prefixes to view all routes with a common
prefix.
list
prefix-list
(OPTIONAL) Enter the keyword list and the name of a configured prefix list. For more
information, refer to the show ip route list command.
protocol
(OPTIONAL) Enter the name of a routing protocol (bgp, isis, ospf, rip) or the
keywords connected or static.
NOTE: bgp, isis, ospf, and rip.
• If you enter bgp, you can include the BGP as-number .
•
If you enter isis, you can include the ISIS routing-tag.
• If you enter ospf, you can include the OSPF process-id.
process-id
(OPTIONAL) Specify that only OSPF routes with a certain process ID must be displayed.
802 IPv4 Routing