Administrator Guide

Column
Heading
Description
Non-active Routes Identifies the back-up routes when a route is learned by two different protocols. If the
best route or active route goes down, the non-active route becomes the best route.
ospf 100 If routing protocols (OSPF, RIP) are configured and routes are advertised, then
information on those routes is displayed.
Total 1388
active...
Displays the number of active and non-active routes and the memory usage of those
routes. If there are no routes configured in the Dell EMC Networking OS, this line does
not appear.
Example
DellEMC> show ip route summary
Route Source Active Routes Non-active Routes
connected 17 0
static 3 0
ospf 100 1368 2
Intra-area: 762 Inter-area: 1 External-1: 600 External-2: 5
Total 1388 2
Total 1388 active route(s) using 222440 bytes
Total 2 non-active route(s) using 128 bytes
DellEMC>
Related
Commands
• show ip route — display information about the routes found in the switch.
show ip traffic
View IP, ICMP, UDP, TCP and ARP traffic statistics.
Syntax
show ip traffic [all | cp | rp1 | rp2]
NOTE: These options are supported only on the E-Series.
Parameters
all (OPTIONAL) Enter the keyword all to view statistics from all processors. If you do not
enter a keyword, you also view all statistics from all processors.
cp (OPTIONAL) Enter the keyword cp to view only statistics from the Control Processor.
rp1 (OPTIONAL) Enter the keyword rp1 to view only the statistics from Route Processor 1.
rp2 (OPTIONAL) Enter the keyword rp2 to view only the statistics from Route Processor 2.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
808 IPv4 Routing