Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

841

842

843

844

845

846

847

848

849

850

To remove the iSCSI session aging time, use the no iscsi aging time command.

Parameters

time

Enter the aging time for the iSCSI session. The range is from 5 to 43,200 minutes.

Defaults 10 minutes

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.0) Introduced on the S6100–ON.

9.10(0.0) Introduced on the S3148.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module.

iscsi cos

Set the QoS policy that is applied to the iSCSI flows.

Syntax

iscsi cos {enable | disable | dot1p vlan-priority-value [remark] | dscp dscp-

value [remark]}

To disable the QoS policy, use the no iscsi cos command.

Parameters

enable Enter the keyword enable to allow the application of preferential QoS treatment to

iSCSI traffic so that the iSCSI packets are scheduled in the switch with a dot1p priority 4

regardless of the VLAN priority tag in the packet. The default is: the iSCSI packets are

handled with dotp1 priority 4 without remark.

disable Enter the keyword disable to disable the application of preferential QoS treatment to

iSCSI frames.

dot1p

vlan-

priority-value

Enter the dot1p value of the VLAN priority tag assigned to the incoming packets in an

iSCSI session. The range is from 0 to 7. The default is the dot1p value in ingress iSCSI

frames is not changed and is the same priority is used in iSCSI TLV advertisements if you

did not enter the iscsi priority-bits command.

dscp

dscp-value

Enter the DSCP value assigned to the incoming packets in an iSCSI session. The valid

range is from 0 to 63. The default is: the DSCP value in ingress packets is not changed.

remark

Marks the incoming iSCSI packets with the configured dot1p or DSCP value when they

egress to the switch. The default is: the dot1and DSCP values in egress packets are not

changed.

Defaults Disabled.