Administrator Guide
• isis ipv6 metric
• isis metric
• isis network point-to-point
• isis password
• isis priority
• is-type
• log-adjacency-changes
• lsp-gen-interval
• lsp-mtu
• lsp-refresh-interval
• max-area-addresses
• max-lsp-lifetime
• maximum-paths
• metric-style
• multi-topology
• net
• passive-interface
• redistribute
• redistribute bgp
• redistribute ospf
• router isis
• set-overload-bit
• show config
• show isis database
• show isis graceful-restart detail
• show isis hostname
• show isis interface
• show isis neighbors
• show isis protocol
• show isis traffic
• spf-interval
adjacency-check
Verify that the “protocols supported” field of the IS-IS neighbor contains matching values to this router.
Syntax
adjacency-check
To disable adjacency check, use the no adjacency-check command.
Defaults Enabled.
Command Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
Intermediate System to Intermediate System (IS-IS) 855