Administrator Guide
Version Description
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.11.1 Introduced on the Z9000.
7.5.1.0 Introduced on the E-Series.
Usage Information
Configure a network entity title (the net command) to specify the area address and the router system ID.
To establish adjacencies and establish dynamic routing, enable routing on one or more interfaces.
You can configure only one IS-IS routing process to perform Level 2 routing. A level-1-2 designation performs
Level 1 and Level 2 routing at the same time.
Related
Commands
• net — configure an IS-IS network entity title (NET) for the routing process.
• is-type — assign a type for a given area.
isis circuit-type
Configure the adjacency type on interfaces.
Syntax
isis circuit-type {level-1 | level-1-2 | level-2-only}
To return to the default values, use the no isis circuit-type command.
Parameters
level-1 You can form a Level 1 adjacency if there is at least one common area address between
this system and neighbors. You cannot form Level 2 adjacencies on this interface.
level-1-2 You can form a Level 1 and Level 2 adjacencies when the neighbor is also configured as
Level-1-2 and there is at least one common area, if not, a Level 2 adjacency is established.
This setting is the default.
level-2-only You can form a Level 2 adjacencies when other Level 2 or Level 1-2 routers and their
interfaces are configured for Level 1-2 or Level 2. Level 1 adjacencies cannot be
established on this interface.
Defaults level-1-2
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
Intermediate System to Intermediate System (IS-IS) 879