Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S4048-ON

891

892

893

894

895

896

897

898

899

900

Version Description

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.12.0 Introduced on the S4810.

8.3.11.1 Introduced on the Z9000.

7.5.1.0 Added support for LSP Throttling Enhancement.

Usage Information To configure the number of area addresses on router, use this command. This value must be consistent with

routers in the same area, otherwise the router forms only Level 2 adjacencies. The value must be same among all

the routers to form Level 1 adjacencies.

max-lsp-lifetime

Set the maximum time that link-state packets (LSPs) exist without being refreshed.

Syntax

max-lsp-lifetime seconds

To restore the default time, use the no max-lsp-lifetime command.

Parameters

seconds

The maximum lifetime of LSP in seconds. This value must be greater than the lsp-

refresh-interval command. The higher the value the longer the LSPs are kept. The

range is from 1 to 65535. The default is

1200.

Defaults 1200 seconds

Command Modes ROUTER ISIS

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.