Concept Guide

SFP+ 1 Diagnostic Information
===================================
SFP+ 1 Rx Power measurement type = OMA
===================================
SFP+ 1 Temp High Alarm threshold = 0.000C
SFP+ 1 Voltage High Alarm threshold = 0.000V
SFP+ 1 Bias High Alarm threshold = 0.000mA
NOTE: In the following show interfaces tengigbitethernet commands, the ports 1,2, and 3 are inactive and no physical
SFP or SFP+ connection actually exists on these ports. However, Dell Networking OS still perceives these ports as valid and the
output shows that pluggable media (optical cables) is inserted into these ports. This is a software limitation for this release.
Dell#show interfaces tengigabitethernet 1/1 transceiver
SFP+ 1 Serial ID Base Fields
SFP+ 1 Id = 0x0d
SFP+ 1 Ext Id = 0x00
SFP+ 1 Connector = 0x23
……………………….
Dell#show interfaces tengigabitethernet 1/2 transceiver
SFP+ 1 Serial ID Base Fields
SFP+ 1 Id = 0x0d
SFP+ 1 Ext Id = 0x00
SFP+ 1 Connector = 0x23
……………………….
Dell#show interfaces tengigabitethernet 1/3 transceiver
SFP+ 1 Serial ID Base Fields
SFP+ 1 Id = 0x0d
SFP+ 1 Ext Id = 0x00
SFP+ 1 Connector = 0x23
……………………….
Dell#show interfaces tengigabitethernet 1/4 transceiver
SFP 1 Serial ID Base Fields
SFP 1 Id = 0x0d
SFP 1 Ext Id = 0x00
SFP 1 Connector = 0x23
SFP 1 Transceiver Code = 0x08 0x00 0x00 0x00 0x00 0x00 0x00 0x00
SFP 1 Encoding = 0x00
………………
………………
SFP 1 Diagnostic Information
===================================
SFP 1 Rx Power measurement type = OMA
===================================
SFP 1 Temp High Alarm threshold = 0.000C
SFP 1 Voltage High Alarm threshold = 0.000V
SFP 1 Bias High Alarm threshold = 0.000mA
Conguring wavelength for 10–Gigabit SFP+ optics
You can set the wavelength for tunable 10–Gigabit SFP+ optics using the wavelength command. To set the wavelength, follow these
steps:
• Enter the interface mode and set the wavelength.
INTERFACE mode
wavelength 1529.0
The wavelength range is from 1528.3 nm to 1568.77nm.
• Verify conguration changes.
446
Interfaces