Connectivity Guide

Supported Releases 10.4.0E(R1) or later
fcoe-pinned-port
Marks a port as a pinned port in the port-channel. This conguration is supported on FSB, Ethernet LAG in NPG, and F_Port mode. It is not
supported on a VLTi LAG.
Syntax
fcoe-pinned-port
Parameters node/slot/port[:subport]—Enter the interface type details.
Defaults Disabled
Command Mode Port-channel INTERFACE
Usage Information You can congure only single port per port-channel. If the port is not congured properly, or if the pinned port goes
down, the other ports in the port-channel are not used even if the ports have valid path to server. The no version
of this command removes the pinned port conguration.
Example
OS10(conf-if-eth-1/1/9)# channel-member 10
OS10(conf-if-eth-1/1/9)# fcoe-pinned-port
Warning: Any existing FCoE session in port-channel will get cleared. Do you
want to continue(yes/no)?yes
Supported Releases 10.4.2.0 or later
fcoe max-sessions-per-enodemac
Congures the maximum number of sessions allowed for an ENode.
Syntax
fcoe max-sessions-per-enodemac max-session-number
Parameters max-session-number — Enter the maximum number of sessions to be allowed, from 1 to 64.
Defaults 32
Command Mode CONFIGURATION
Usage Information
The no version of this command resets the number of sessions to the default value.
Example
OS10(config)# fcoe max-sessions-per-enodemac 64
Supported Releases 10.4.0E(R1) or later
fcoe priority-bits
Congures the priority bits for FCoE application TLVs.
Syntax
fcoe priority-bits priority-value
Parameter priority-value — Enter PFC priority value advertised in FCoE application TLV. You can enter one of the
following values: 0x01, 0x02, 0x04, 0x08, 0x10, 0x20, 0x40, or 0x80.
Default 0x08
Command Mode CONFIGURATION
Fibre Channel 157