Connectivity Guide

Congure advertise LLDP-MED network policies
OS10(conf-if-eth1/1/5)# lldp-med network-policy add 1
Fast start repeat count
Fast start repeat count enables a network-connectivity device to advertise itself at a faster rate for a limited amount of time. The fast start
timer starts when a network-connectivity device receives the rst LLDP frame from a newly detected endpoint.
When an LLDP-MED endpoint is newly detected or connected to the network, the lldp-med fast-start-repeat-count
command enables the network to quickly detect the endpoint. The LLDP-MED fast start repeat count species the number of LLDP
packets that send during the LLDP-MED fast start period. By default, the device sends three packets per interval. Change the number of
packets a device sends per second a maximum of 10.
Rapid availability is crucial for applications such as emergency call service location (E911).
• Enable fast start repeat count which is the number of packets sent during activation in CONFIGURATION mode, from 1 to 10, default 3.
lldp-med fast-start-repeat-count number
Congure fast start repeat count
OS10(config)# lldp med fast-start-repeat-count 5
View LLDP conguration
• View the LLDP conguration in EXEC mode.
show running-configuration
• View LLDP error messages in EXEC mode.
show lldp errors
• View LLDP timers in EXEC mode.
show lldp timers
• View the LLDP trac in EXEC mode.
show lldp traffic
View running conguration
OS10# show running-configuration
View LLDP errors
OS10# show lldp errors
Total Memory Allocation Failures : 0
Total Input Queue Overflows : 0
Total Table Overflows : 0
View LLDP timers
OS10# show lldp timers
LLDP Timers:
Holdtime in seconds: 120
Reinit-time in seconds: 2
Transmit interval in seconds: 30
View LLDP global trac
OS10# show lldp traffic
LLDP traffic statistics:
Total Frames Out : 0
Total Entries Aged : 0
200
Layer 2