Connectivity Guide

lldp reinit
Congures the delay time in seconds for LLDP to initialize on any interface.
Syntax
lldp reinit seconds
Parameters seconds — Enter the delay timer value in seconds, from 1 to 10.
Default 2 seconds
Command Mode CONFIGURATION
Usage Information The no version of this command resets the value to the default.
Example
OS10(config)# lldp reinit 5
Supported Releases 10.2.0E or later
lldp timer
Congures the rate in seconds at which LLDP packets send to the peers.
Syntax
lldp timer seconds
Parameters seconds — Enter the LLDP timer rate in seconds, from 5 to 254.
Default 30 seconds
Command Mode CONFIGURATION
Usage Information The no version of this command sets the LLDP timer back to its default value.
Example
OS10(config)# lldp timer 25
Supported Releases 10.2.0E or later
lldp tlv-select basic-tlv
Enables or disables TLV attributes to transmit and receive LLDP packets.
Syntax
lldp tlv-select basic-tlv {port-description | system-name | system-description
| system-capabilities | management-address}
Parameters
• port-description — Enable or disable the port description TLV.
• system-name — Enable or disable the system TLV.
• system-description — Enable or disable the system description TLV.
• system-capabilities — Enable or disable the system capabilities TLV.
• management-address — Enable or disable the management address TLV.
Default Enabled
Command Mode INTERFACE
Usage Information None
Layer 2 207