Connectivity Guide

• receive — Receive multiple paths from the peer.
• send path count — Enter the number of multiple paths to send multiple to the peer, from 2 to 64.
Default Not congured
Command Mode ROUTER-BGP-NEIGHBOR-AF
Usage Information Advertising multiple paths to peers for the same address prex without replacing the existing path with a new one
reduces convergence times. The no version of this command disables the multiple path advertisements for the
same destination.
Example (IPv4)
OS10(conf-router-bgp-af)# add-path both 64
Example (IPv6)
OS10(conf-router-bgpv6-af)# add-path both 64
Example (Receive)
OS10(conf-router-bgpv6-af)# add-path receive
Supported Releases 10.2.0E or later
address-family
Enters Global Address Family Conguration mode for the IP address family.
Syntax
address-family {[ipv4 | ipv6] unicast}
Parameters
• ipv4 unicast — Enter an IPv4 unicast address family.
• ipv6 unicast — Enter an IPv6 unicast address family.
Default None
Command Mode ROUTER-BGP
Usage Information This command applies to all IPv4 or IPv6 peers belonging to the template or neighbors only. The no version of this
command removes the subsequent address-family conguration.
Example (IPv4
Unicast)
OS10(config)# router bgp 3
OS10(conf-router-bgp-3)# address-family ipv4 unicast
OS10(conf-router-bgpv4-af)#
Example (IPv6
Unicast)
OS10(config)# router bgp 4
OS10(conf-router-bgp-4)# address-family ipv6 unicast
OS10(conf-router-bgpv6-af)#
Supported Releases 10.3.0E or later
advertisement-interval
Sets the minimum time interval for advertisement between the BGP neighbors or within a BGP peer group.
Syntax
advertisement-interval seconds
Parameters seconds—Enter the time interval value in seconds between BGP advertisements, from 1 to 600.
Default EBGP 30 seconds, IBGP 5 seconds
Command Mode ROUTER-NEIGHBOR
Layer 3 353