Connectivity Guide

Table Of Contents
ip address
Congure the IP address to an interface.
Syntax
ip address ip–address/mask
Parameters ip–address/mask — Enter the IP address.
Defaults None
Command Mode INTERFACE
Usage Information The no version of this command removes the IP address set for the interface.
Example
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# ip address 10.1.1.0/24
Supported Releases 10.3.0E or later
ip address dhcp
Enables DHCP client operations on the interface.
Syntax
ip address dhcp
Parameters None
Defaults None
Command Mode INTERFACE
Usage Information The no version of this command disables DHCP operations on the interface.
Example
OS10(config)# interface mgmt 1/1/1
OS10(conf-if-ma-1/1/1)# ip address dhcp
Supported Releases 10.3.0E or later
ip arp
Congures static ARP and maps the IP address of the neighbor to a MAC address.
Syntax
ip arp mac-address
Parameters mac-address — Enter the MAC address of the IP neighbor in A.B.C.D format.
Default Not congured
Command Mode INTERFACE
Usage Information Do not use Class D (multicast) or Class E (reserved) IP addresses. Zero MAC addresses (00:00:00:00:00:00) are
invalid. The no version of this command disables the IP ARP conguration.
Example
OS10(conf-if-eth1/1/6)# ip arp 10.1.1.5 08:00:20:b7:bd:32
Supported Releases 10.2.0E or later
392 Layer 3