Connectivity Guide

• max-interval — 5000 milliseconds
Command Mode ROUTER-OSPF
Usage Information The no version of this command removes the LSA transmit timer.
Example
OS10(config)# router ospf 10
OS10(conf-router-ospf-10)# timers throttle lsa all 100 300 1000
Supported Releases 10.2.0E or later
OSPFv3
OSPFv3 is an IPv6 link-state routing protocol that supports IPv6 unicast address families (AFs). OSPFv3 is disabled by default. You must
congure at least one interface, either physical or Loopback. The OSPF process automatically starts when OSPFv3 is enabled for one or
more interfaces. Any area besides area 0 can have any number ID assigned to it.
Enable OSPFv3
1 Enable OSPFv3 globally and congure an OSPFv3 instance in CONFIGURATION mode.
router ospfv3 instance-number
2 Enter the interface information to congure the interface for OSPFv3 in INTERFACE mode.
interface ethernet node/slot/port[:subport]
3 Enable the interface in INTERFACE mode.
no shutdown
4 Disable the default switchport conguration and remove it from an interface or a LAG port in INTERFACE mode.
no switchport
5 Enable the OSPFv3 on an interface in INTERFACE mode.
ipv6 ospfv3 process-id area area-id
• process-id — Enter the OSPFv3 process ID for a specic OSPFv3 process, from 1 to 65535.
• area-id — Enter the OSPF area ID as an IP address in A.B.C.D format or number, from 1 to 65535.
Enable OSPFv3
OS10(config)# router ospfv3 100
OS10(config-router-ospfv3-100)# exit
OS10(config)# interface ethernet 1/1/1
OS10(conf-if-eth1/1/1)# no shutdown
OS10(conf-if-eth1/1/1)# no switchport
OS10(conf-if-eth1/1/1)# ipv6 ospfv3 300 area 0.0.0.0
Enable OSPFv3 in a non-default VRF instance
1 Create the non-default VRF instance in which you want to enable OSPFv3:
ip vrf vrf-name
CONFIGURATION Mode
2 Enable OSPFv3 in the non-default VRF instance that you created earlier and congure an OSPFv3 instance in VRF CONFIGURATION
mode.
router ospfv3 instance-number vrf vrf-name
468
Layer 3